I REMOTE CONTROL MANUAL g g. II. II. II. | g. II g. II g. I li g a. Serial Number. May MODELS /14/20/24/30/ DUAL- AND QUAD-CHANNEL. 5 Manual Operation. Vertical Controls. Time-Base Controls. Probes. Bandwidth Limit. Trigger controls (Standard). Displaying Traces. Display Control and. See Remote Control Manual. 6FRSH ([SORUHU. Also via GPIB and RSC, the Scope Explorer software integrates the oscilloscope with Windows 95 and.
|Published (Last):||11 July 2016|
|PDF File Size:||6.65 Mb|
|ePub File Size:||6.85 Mb|
|Price:||Free* [*Free Regsitration Required]|
I’ve checked the voltages from the PSU not under load and they are all correct. Priority is given to the main processor. I would start with the timebase board.
LeCroy 9410 Manuals
In parallel a 1 KOhm resistor is added. If no trigger occurs, one is generated at an appropri- ate rate.
Power spectral density PSD in dBm. The deflection angle depends slightly on the anode voltage. It is marked A LeCro v Figure Check oscillators and other timing things. The difference time reading must be within 9. For applications where throughput is critical, the 0’s GPIB interface can be used to transfer hundreds of waveforms per second. The picture above shows a modulated signal top trace analyzed in frequency do- main.
Mass storage – A credit card memory system can be added to the for applications requiring high- speed data logging and non-volatile waveform storage. Holds display after a trigger occurs. Time-domain averaging – Averaging real-time signals prior to FFT execution maanual increase the dynamic range up to Frequency cursors – Cursors give up to 0.
I have fixed weird problems in instruments of this vintage just by reseating chips in their sockets. Slide the board out of the F front panel. The increment may be positive or negative.
A special hardware feature of the F diaplay is the 94410 vectors with an intensified point at the end, used to highlight the actual digitized data points out of the linear interpolation. They are selected through simple menus that allow functions to be chained together allowing more complex computations.
Also look for bad manula the axial blue electrolytics. The DCK signal is a delayed clock used by the time base for exact timing.
For safety reasons, unplug the mains cable from the outlet without turning the scope off. While Vin and Vout are different, the capacitor is charged or discharged with a rate given by Iin, the integrator current, until Vout reaches Vin. Information in this publication supersedes al. Additive constant on input: The same buffer is used for the offset control. High-speed processing is used to instantly update results with each new acquisition.
Each channel maanual tains a high-resolution flash ADC which digitizes Signal processing – The 0’s built-in processing includes mathematics add, subtract and invertXY display with ratio and multiplication cursor read- out, and summation averaging up to sweeps.
It is the user’s responsibility to make sure that the data in the memory makes sense to the display processor.
Teledyne LeCroy – Product Manuals – Oscilloscopes
Using memory C and D for intermediate results, any number of operations can be chained manu- ally or via remote control. Gain 1 – Offset: Address switches on rear panel. Versatile display formats – Frequency-domain data may be presented lscroy magnitude, phase, real, imaginary, com- plex.