Kenwood TKR UHF Base Station/Repeater, MHz, W. Includes : DC Power Cable, rack handles and hardware, DC power supply adjustable. VHF/UHF FM Repeater-Base Units. General Features. 19″ Rack Mount Design; Primary DC Input Connector; Auto-Switched Back-Up DC Input Connector. TKR contains many Programmable Functions tabled below. Programmable cable, E, which is available from the KENWOOD parts center.
|Published (Last):||27 June 2016|
|PDF File Size:||5.46 Mb|
|ePub File Size:||3.47 Mb|
|Price:||Free* [*Free Regsitration Required]|
If you find one of the first version repeaters they had a recall on the PA board and it was a dirrect replacement and is easy to install. Our club has a TKR V2. This has been tested and working. Email Subscription You are not subscribed to this review. Decent appearance, not beat up or dirty.
Kenwood Tkr-850 Type1 Repeater With Duplexer
Browse Related Browse Related. All new quality materials. If you have any questions feel free to message me. Morse code IDs are attenuated if the repeater is in us This repeater along with the duplexer has been tested and calibrated with an IFR service monitor; it has a pair of frequencies programmed with DCS Digital Tonethe RX side has excellent sensiti However i recomend if your using them in Ham use spend the extra and use an external controller FCC Requirement to remotely control the repeater.
Recently removed from active service in Ham bands. Number of bids and bid amounts may be slightly out of date.
Kenwood TKR Product Reviews
Up for sale is: We’ve had 6 of the UHF Kenwoods in service for a regional health care tr-850 primarily at local hospitals since and all feeding into a common hub repeater. Contact the site with comments or questions. An all around great machine. Sorry if this is an inconvenience. All of the repeaters are the TKRK.
Kenwood TKR-750 / TKR – 850
See each listing for international shipping options and costs. Kenwood TKR Repeater in very good conditions and fully working. This page was last updated: The exciter is operating 10 watts out into my PA delivering a nice signal with outstanding audio!
See condition above for more details.
Some of them are the first version 1. If the selection was available on this site for a better rating I would rate it at ienwood 4. You can toggle the Kenwood outbound tone to drop when inbound tone drops – nice feature. All IDs are “polite”. I have tried many other models of controllers and found that the RLC-4 and knewood Kenwood mated together are a perfect match.
The new version includes more DTMF remote control feature then the older v1 repeaters I have used in the past. Power and receivers have been checked. I have this repeater on the Ham band and it works flawlessly. These cables are not fused. Also shop in Also shop in.
We matched the TKRs and several s to the Arcom controller. Including all spare parts This kenwopd will be sold “as-is” in used condition.
Buy 5 and Get 6th unit free. Not a MTR, but for a fraction of the price, the performance specs are very close. Make a very good GMRS repeater. Being a Kenwood Dealer i make special deals for clubs and hams. Digital Paging Encoder Input.
Super easy to set up. After looking to buy a used machine and rebuild, I decided ,enwood just buy a new one. I have given it a 4 as I have only owned it for a few months, so it has very low run time, but so far it has performed well. Super easy to align the front end for the 70cm band.
What you see is what you get. Includes item s seen in picture s. I have kfnwood than 18 of these repeaters in HAM repeater use. Sure, the repeater has a basic controler and it does a terrific job.
You can disable it via the internal controller but if someone is jamming your repeater its nice to come in on a full duplex link or external receiver. The kenood is very basic, but it will satisfy the minimum requirements.